Peugeot 308 Key Fob Replacement
Peugeot's 308 might seem somewhat old-fashioned but it's eye-catching. It might not be the most luxurious car in its class - it's a Ford Focus or Volkswagen Golf will isolate you even better from road imperfections, but it's still a pleasant and civilised drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. Whether the problem is constant or intermittent the following tips will help.
Water Damage
If you accidentally drop your key fob in an eddy, or it is soaked while kayaking, canoeing or rafting or canyoning, the fob is likely to be damaged by water. Keep your key fob in a dry bag every time you go outside or engage in things that expose it to excessive amounts water.
You should also make sure that the fob is completely dry prior to opening it and reusing it. If you smell any odors emanating from the fob (such as industrial liquid or windshield washer fluid) This is a further indication that it's been submerged.
A wet circuit can cause the battery's power to be depleted or even explode. If you can get your 308 keyfob out of the water you need to turn the button side up and shake as much water as you can before opening the casing. Remove the battery, then wipe the circuit board clean using a cotton swab which has been submerged in 90 percent alcohol.
Other reasons that your Peugeot 308 remote entry keyless system might not function could be due to a dead coin-cell battery or receiver module issue signal interference or a malfunctioning chip. If none of these are the problem you can reset the system by disconnecting the 12 Volt battery from the car for 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote start system which allows drivers to start their vehicle from the distance, allowing them to warm up or cool down the vehicle before they get in. This feature is extremely useful, especially during cold winter months. However, there are times when the remote start system stops functioning due to a variety of reasons, like an unresponsive coin battery.
A coin-shaped battery located inside the key fob will last a time of between two and four years, depending on how often it is utilized and where it was purchased. The use-by date will be printed on the packaging or mentioned in the user's manual.
If the key fob has stopped working after exposure to clean tap water it is recommended to remove the battery, then clean the chip with a paper towel and isopropyl Alcohol, then dry it thoroughly before replacing it. If the key fob has been exposed to soapy or salty water, it could have fried the chip. You'll need to replace it.
If you're not certain the battery is in good condition, you can test the voltage with a multimeter set to the vehicle's voltage range and connected to the minus and plus terminals. The voltage should range from 12-13 volts, but if it's lower, the battery should be replaced. You can also try to reset your on-board computer by disconnecting the battery with 12 volts for a short period of time, and reconnecting it in reverse order (positive cable first followed by negative). The engine should then start after this.
Faulty Receiver Module
If you're not receiving the "Key Detected" message on your dashboard, it's possible the receiver module has discovered a problem. It's the component that sends an alarm to the car when the key fob is activated it also acts as an immobiliser, and stops it from starting until the correct key is used.
This could result from a variety of causes, such as water damage or simply ageing. If peugeot spare key G28CarKeys within your Peugeot 308 keyfob is damaged by dirty tap water It could be because the keyfob was exposed to it. In this instance it is necessary to take the device apart and clean it thoroughly using isopropyl alcohol or an electronic cleaner. Once the battery is dry you can try it again.
If the issue persists the issue persists, it's a good option to consult a local Peugeot specialist or locksmith. They can utilize a diagnostic tool in order to pinpoint the issue and repair it.
Losing your Peugeot keys to your car is an emotional experience. However, a professional auto locksmith can fix the problem in minutes. They can cut a brand new key and program it to your vehicle, making sure you're ready to get on the road again as fast as you can. Find locksmiths near you.
Electronic chip malfunctions
The electronic chip in the Peugeot 308 key fob plays an essential role in the remote control system. If the chip is damaged, you could have problems starting your car or receive a message stating "anti-theft". If this occurs, the only option to fix the issue is to get a new key. Professional auto locksmiths can provide this service in the shortest time.
The chip in your Peugeot 308 key fob can become faulty due to sweat, water damage dirt, or other causes. If your Peugeot 308 key fob is exposed to soapy water, you should take it to the cleaners immediately. You can wipe the electronic component with a paper towel soaked in isopropyl Alcohol. The battery should then be allowed to dry completely.
Radio interference can cause a key fob to stop functioning. This can happen when other devices operate on the same frequency as your Peugeot keyfob. It could be caused by poor conditions or objects in the vicinity of the vehicle. If you encounter this issue it is recommended to visit an Peugeot dealership.
The Peugeot 207/308 Key Fob is very delicate and requires special care. It is not recommended to drop it or throw it around. If you lose something, try to find it as quickly as you can. You can reset your on-board computer by disconnection of the battery for a couple of minutes. Make sure you disconnect the negative cable first, and then the positive.